{INCLUDE _LOGOS.HTM}

PicLan-IP Installation
Native Hosts

In order to install PicLan-IP, you must have one of the following Pick host systems (additional hosts will be supported in future releases):

AP/Pro 6.1
Mentor PRO 4.0
Mentor PRO 4.1
Sequoia PRO 2.4.x

On each system, you must have installed:

PicLan version 2.0.0.5 or later (2.0.0.13 or later for Sequoia PRO)
A supported PicLan Ethernet adapter

You must install PicLan before you install PicLan-IP. You should test PicLan IPX connections before installing PicLan-IP.

Installing the PICLAN-IP Account

The PICLAN-IP account is installed in a manner very similar to the PIC-LAN account. You follow these steps:

Download the PicLan-IP .ZIP file from the modsoft.com web site. Be sure to download the version that matches your host system.
Follow the directions on the PicLan-IP download page to create PicLan-IP installation diskettes.
Load the PICLAN-IP account onto your system:

For AP/Pro

Log to the 'dm' account.
Execute the following TCL commands:

SET-FLOPPY (HA
T-ATT
T-REW
T-LOAD MD (O
INSTALL

For Mentor PRO

Log to the 'SYSPROG' account.
Execute the following TCL commands:

T-SELECT 0
T-ATT
T-REW
T-LOAD MD (O
INSTALL

For Sequoia PRO

Log to the 'SYSPROG' account.
Execute the following TCL commands:

SET-FLOPPY (HA
T-ATT
T-REW
T-LOAD MD (O
INSTALL

The PicLan-IP INSTALL proc will execute. It will prompt you to continue.
The PICLAN-IP account will then be loaded. This is actually an account-restore renaming the account from PLIP-1.0 to PICLAN-IP.

Once the PICLAN-IP account is loaded, you need to:

Execute UPDATE-PICLAN to update a number of items in the PIC-LAN account.
Re-boot your host system to load the new PicLan Ethernet drivers and PicLan-IP TCP/IP stacks.
After booting your system, execute the PL-STAT command and verify that your PicLan version number is now 2.0.0.100 or higher.

Next, you need to configure the PicLan-IP configuration files. This process sets your IP network address and routing parameters. If you have configured TCP/IP systems before, this should look very familiar. If you have not configured TCP/IP systems before, you may need assistance with this. After the PicLan-IP configuration files are configured, you execute PLIP-INIT to actually initialize the PicLan-IP TCP/IP stack as well as allocating additional system memory for TCP/IP connection tables and buffers. At this point, you should be able to PING the Pick host system from another system on the TCP/IP network. If you cannot PING the Pick host, then something in your configuration is incorrect.

At this point the PicLan-IP TCP/IP stack is running and you can proceed to configuring the PicLan-IP Web Server.
{INCLUDE _GEN_FTR.HTM}

PicLan-IP Installation Native Hosts

Installing the PICLAN-IP Account

PicLan-IP Installation
Native Hosts